Cast Iron Gear Motors

Specifically designed for demanding mobile equipment applications where maximum performance is required at peak power levels and operating temperatures our Cast Iron Motors ensure great productivity and excellent fuel efficiency along with reduced vehicle emissions.

 

D-Motor

cast iron gear motor

The compact size, with side and rear port options, add to design flexibility for installation in tighter places. Additionally 

the use of high temperature seals and a dust resistant shaft seal protector improve performance and help extend operating life.

The D-motor differs slightly from the D-pumps in internal design. The D-pump uses a thicker dual pressure-balanced thrust plate design to ensure high starting torque and long life with lower viscosity oils The design of the body allows for high axial and radial external loads without the need for an outrigger bearing assembly. Additionally for fan drive applications, a variety of valve options are offered for great flexibility to allow for integrated reversing, proportional relief, fixed relief, and anti-cavitation valves.

 

Product Group Level Flange Size Displacement cm³/rev
[in³/rev]
Rated Pressure [psi]* Maximum Speed
min-1
[rpm]*
Technical Information
D Series Motor Group 2.5 SAE A or B 17.6-48.3
[1.08-2.95]
276 [4,000] 3,400 (PDF)

 

* Note, ratings are not applicable for all displacements. See technical literature for further details.

 

 

Cascade

cast iron gear motor

As with the D-pump, Turolla's cast-iron portfolio has increased to group 3 products with Cascade and Dolomites. Currently any of the Cascade units are configurable to be used as pumps or as motors. Motor options allow for internal or external drains, outrigger bearings, as well as mounting and drive options typically found across a broad range of group 2, group 3 and even group 4 motors.

 

Product Group Level Flange Size Displacement cm³/rev
[in³/rev]
Rated Pressure [psi]* Maximum Speed
min-1
[rpm]*
Technical Information
Cascade Group 3 SAE-A, SAE-B, SAE-C, ISO 17.4-71.0
[1.06-4.33]
300 [4,350] 3,200 (PDF)
 

* Note, ratings are not applicable for all displacements. See technical literature for further details.

 

Dolomites

cast iron gear motor

Just as the Cascade group 3 motors can be configured from all the same Cascade group 3 pump options, Dolomites group 3 motors are fully configurable from the same offerings as the Dolomites group 3 pumps. Options aren't as plentiful compared to the Cascade, but for a true group 3 cast iron motor the Dolomites is a strong offering.

 

Product Group Level Flange Size Displacement cm³/rev
[in³/rev]
Rated Pressure [psi]* Maximum Speed
min-1
[rpm]*
Technical Information
Dolomites Group 3 SAE-B, SAE-C, ISO, EU 4-bolt 10.1-100.0
[0.62-6.10]
290 [4,250] 3,200 (PDF)
 

* Note, ratings are not applicable for all displacements. See technical literature for further details.

 
 
More in this category: « Cast Iron Gear Pump
JoomShaper